Mazda 6 Service Manual: Base removal
1. Remove the rearview mirror.
2. Wind each end of a wire around a bar.
Warning
- Using a SST (piano wire) with bare hands can cause injury. Always wear gloves when using a SST (piano wire).
Note
- Use a long sawing action to spread the work over the whole length of the SST (piano wire) to prevent it from breaking.
3. Saw through the sealant to remove the base.
Rearview mirror installation
Install the rearview mirror onto the base.
...
Base installation
1. Cut away all of the original sealant using a razor.
2. Clean and degrease the ceramic coating on the glass and the base.
3. Apply primer to the bonding area of the glass and the base.
Caution
...
Other materials:
Mazda 6 Service Manual: Indicators
Manual shift mode indication
In manual shift mode, the “M” of the shift position indication in the instrument
panel illuminates.
Gear position indication
The numeral for the selected gear illuminates.
NOTE
If the gears cannot be shifted down when driving at higher speeds, the
gear ...
Mazda 6 Service Manual: Windshield wiper motor inspection
L.H.D.
1. Disconnect the windshield wiper motor connector.
2. Connect battery positive voltage to terminal E or D and ground to terminal
B, and inspect the operation of the windshield wiper motor as indicated below.
3. Disconnect battery positive voltage from terminal E of the motor while t ...