L.H.D.
1. Disconnect the windshield wiper motor connector.
2. Connect battery positive voltage to terminal E or D and ground to terminal B, and inspect the operation of the windshield wiper motor as indicated below.
3. Disconnect battery positive voltage from terminal E of the motor while the wipers are operating.
4. Verify that the wipers do not stop in the park position.
5. Short between the motor terminals A and D and connect battery positive voltage to the motor terminal C.
6. Verify that the wipers operate at low speed again, then stop in the park position.
R.H.D.
1. Disconnect the windshield wiper motor connector.
2. Connect battery positive voltage to terminal B or A and ground to terminal D, and inspect the operation of the windshield wiper motor as indicated below.
3. Disconnect battery positive voltage from terminal B of the motor while the wipers are operating.
4. Verify that the wipers do not stop in the park position.
5. Short between the motor terminals E and A and connect battery positive voltage to the motor terminal C.
6. Verify that the wipers operate at low speed again, then stop in the park position.
Mazda 6 Service Manual: Reassembly
Standard values, such as torques and certain adjustments, must be
strictly observed in the reassembly of all parts.
If removed, these parts should be replaced with new ones:
- Oil seals
- Gaskets
- O-rings
- Lockwashers
- Cotter pins
- Nylon nuts
Depen ...
Mazda 6 Service Manual: General procedures
Wheels and Tires Removal/Installation
The removal and installation procedures for the wheels and tires are not
mentioned in this section. When a wheel is removed, tighten it to 88-118 N·m
{9.0-12.0 kgf·m, 65.0-87.0 ft·lbf}.
Power Steering Components Removal/Installation
If any power steeri ...