1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. Adjust the windshield wiper arm and blade. (See WINDSHIELD WIPER ARM AND BLADE ADJUSTMENT.)
Windshield Wiper Arm Installation Note
Clean the windshield wiper arm connector shafts using a wire brush before installing the windshield wiper arms.
Mazda 6 Service Manual: Power window main switch inspection
Drivers side
1. Remove the driver-side front door trim.
2. Connect the power window main switch connector.
3. Measure the voltage at the power window main switch terminals as indicated
below.
4. Disconnect the power window main switch connector before inspecting for
continuity at terminals 1 ...
Mazda 6 Service Manual: No.8 no cool air
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while performing the inspection to discover
whether poor contact points are the cause of any intermittent malfunctions.
If there is a problem, check to make sure connectors, terminals ...