Mazda 6 Service Manual: Front side trim removal/installation
1. Remove the front scuff plate.
2. Turn the seaming welt over.
3. Pull the front side trim toward you, then disengage clip A and the stud bolt, then remove the front side trim.
4. Install in the reverse order of removal.
B-pillar upper trim removal/installation
1. Remove the upper anchor of the front seat belt.
2. Remove the B-pillar lower trim.
3. Turn the seaming welt over.
4. Pull the B-pillar upper trim toward you, then disengage, clip B, and pin C ...
Front scuff plate removal/installation
1. Pull the front scuff plate upward, then disengage clips B, pins C, D and
hooks E from the body, and remove the front scuff plate.
2. Install in the reverse order of removal. ...
Other materials:
Mazda 6 Service Manual: Front Seat Belt Pretensioner and Load Limiting Systems
For optimum protection, the driver and front passenger seat belts are equipped
with pretensioner and load limiting systems. For both these systems to work properly
you must wear the seat belt properly.
Pretensioners:
When a collision is detected, the pretensioners deploy simultaneously with th ...
Mazda 6 Service Manual: How to connect USB port/Auxiliary jack
Connecting a device
1. Open the console lid.
2. Connect the connector on the device to the USB port.
Connecting with a connector cable
1. Open the console lid.
2. Connect the device plug/connector cable to the auxiliary jack/USB port. Pass
the device plug/connector cable through the notch i ...