Mazda 6 Service Manual: Body shell

Seat warmer unit inspection

1. Remove the front seat. (See FRONT SEAT REMOVAL/INSTALLATION.) 2. Remove the seat cushion trim. 3. While inspecting for continuity between the terminals A and B of the connector, use a dryer to ...

Shroud panel removal/installation

1. Remove the bonnet. (See BONNET REMOVAL/INSTALLATION.) 2. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION.) 3. Remove the front combination light. (See FRONT COMBINATION LIGHT RE ...

Other materials:

Mazda 6 Service Manual: Procedures for determining the location of a malfunction
System Wiring Diadram PCM 1. Check the display of DTC U0121 and/or U0155, using the SST (WDS or equivalent). (See DTC TABLE.) 2. Referring to the following table, determine the malfunctioning part of the CAN system. ABS/TCS HU/CM or DSC HU/CM 1. Accec and monitor the PCM MSG and IC MSGo ...

Mazda 6 Service Manual: Pcm configuration
1. Connect the WDS to DLC-2. 2. Set up the WDS (including the vehicle recognition.) 3. Select Module programming. 4. Select Programmable module installation. 5. Select PCM and perform procedures according to directions on the WDS screen. Note If PCM CONFIGURATION is successful, the PCM ...