Mazda 6 manuals

Mazda 6 Service Manual: Front door glass removal/installation

Mazda 6 Service Manual / Body / Door / Front door glass removal/installation

1. Operate the front door glass so that the distance from the top of the front door glass to the upper part of the rear beltline molding is 210 mm {8.3 in}.


2. Disconnect the negative battery cable.

3. Remove the front door trim.

4. Remove the hole cover.

5. Remove the screws.


6. Insert your hand in hole of the front door unit, and lift out the front door glass.

7. Install in the reverse order of removal.

Door adjustment
1. Measure the gap and height between the front or rear door and the body. 2. If not as specified, loosen the front or rear door hinge installation bolts or the door lock striker installation screw ...

Rear door glass removal/installation
1. Fully down the rear door glass. 2. Remove the rear door trim. 3. Remove the hole cover. 4. Pull up the rear door weatherstrip and remove the screw. 5. Remove the bolt. 6. Remove the glass run ...

Other materials:

Mazda 6 Service Manual: Warning Light and Brake Pad Wear Indicator
Warning Light The warning light turns on when the system has a malfunction. Refer to Warning Indication/Warning Lights Brake Pad Wear Indicator When the disc brake pads become worn, the built-in wear indicators contact the disc plates. This causes a screeching noise to warn that the pads shoul ...

Mazda 6 Service Manual: Oil seal (differential) replacement
1. On level ground, jack up the vehicle and support it evenly on safety stands. 2. Drain the oil from the transaxle. 3. Remove the front wheels and splash shields. 4. Separate the drive shaft and joint shaft from the transaxle. (See DRIVE SHAFT REMOVAL/INSTALLATION.) (See JOINT SHAFT REMOVAL/ ...

© 2016-2025 Copyright www.mazda6info.net