1. Use isopropyl alcohol to clean around the damaged section of the filament.
2. Attach tape above and below the damaged section of the filament.

3. Using a small brush or marking pen, repair the filament with silver paint or equivalent.
4. After 2-3 minutes,
carefully remove the tape without disturbing the repaired area.
Caution
5. Use a hot air blower heated to 150 °C {302 ° F}
for 30 minutes
or let the paint set for 24 hours at 25 ° C {77 ° F}
to allow it to dry completely.
Filament inspectionMazda 6 Service Manual: Rear door garnish installation
Note
Double-sided adhesive tape has already been attached to the new
rear door garnish.
Warning
Using a razor with bare hands can cause injury. Always wear gloves
when using a razor.
1. When installing a new rear door garnish, follow the procedure below:
(1) Remove the adhesi ...
Mazda 6 Service Manual: Air bleeding
1. Inspect the fluid level. (See POWER STEERING FLUID INSPECTION.)
2. Jack up the front of the vehicle and support it on safety stands.
3. Turn the steering wheel fully to the left and right several times with the
engine not running.
4. Reinspect the fluid level.
If it has dropped, add flui ...