Mazda 6 Service Manual: Troubleshooting [power window system]
Mazda 6 Service Manual / Body / Troubleshooting [power window system]
- Intermittent concern troubleshooting
- Foreword
- Basic power window system inspection
- Troubleshooting index
- No. 1 driver-side front window does not go up and down in automatic mode
- No. 2 driver-side front window does not reverse, even when encountering a foreign object in its path
- No. 3 driver-side front window reverses even though the glass does not encounter a foreign object while it is going up in automatic mode
Cowl panel removal/installation
1. Remove the windshield wiper arm and blade. (See WINDSHIELD WIPER ARM AND
BLADE REMOVAL/INSTALLATION.)
2. Remove the cowl grille.
3. Remove the windshield wiper motor. (See WINDSHIELD WIPER MOTO ...
Intermittent concern troubleshooting
Vibration Method
If malfunction occurs or becomes worse while driving on a rough road or
when engine is vibrating, perform the steps below.
Note
There are several reasons why vehicle or ...
Other materials:
Mazda 6 Service Manual: Thermostat
THERMOSTAT REMOVAL/INSTALLATION
1. Remove the plug hole plate.
2. Disconnect the negative battery cable.
3. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.)
4. Remove the drive belt. (See DRIVE BELT REPLACEMENT.)
5. Remove the washer tank.
6. Remove the P/S oil pump.
Note
...
Mazda 6 Service Manual: Climate control unit removal
1. Disconnect the negative battery cable.
2. Disconnect the air mix and airflow mode wires from each wire clamp and
link. (Manual air conditioner)
3. Remove the center panel. (See CENTER PANEL MODULE REMOVAL/INSTALLATION.)
4. Remove the screws and climate control unit. (Full-auto air conditione ...
© 2016-2026 Copyright www.mazda6info.net