Mazda 6 Service Manual: Door lock timer unit removal/installation
1. Disconnect the negative battery cable.
2. Remove the glove compartment. (L.H.D.)
3. Remove the bolt.
4. While inclining the door lock timer unit along the body panel in the direction indicated by the arrow, disengage the bracket hook from the hole in the body panel.
5. Disconnect the door lock timer unit connector.
6. Remove the door lock timer unit.
7. Remove the screw, then remove the bracket.
Note
- The screw which fixes the door lock timer unit and bracket is for a body ground connection. Be sure to secure the screw when installing.
8. Install in the reverse order of removal.
Liftgate lock actuator inspection
1. Disconnect the liftgate lock actuator connector.
2. Apply battery positive voltage to the liftgate lock actuator terminals and
inspect the operation of the liftgate lock actuator.
If not as ...
Door lock timer unit inspection
1. Measure the voltage at the door lock timer unit terminals (other than
terminal 1E and 2W) as indicated below.
If not as specified, inspect the parts listed under Action.
2. Disconnect the ...
Other materials:
Mazda 6 Service Manual: Vehicle Loading
WARNING
Do not tow a trailer with this vehicle: Towing a trailer with this
vehicle is dangerous because it has not been designed to tow a trailer and doing
so will affect the drive system which could result in vehicle damage.
This section will guide you in the proper loading of your vehicle, t ...
Mazda 6 Service Manual: Transaxle fluid temperature (tft) sensor removal/installation
Warning
When the transaxle and ATF are hot, they can badly burn. Turn off
the engine and wait until they are cool before replacing the ATF.
1. Remove the oil pan. (See CONTROL VALVE BODY REMOVAL.)
2. Disconnect the TFT sensor connector.
3. Remove the TFT sensor.
4. Install a TFT senso ...