Mazda 6 Service Manual: Transaxle fluid temperature (tft) sensor removal/installation
Warning
- When the transaxle and ATF are hot, they can badly burn. Turn off the engine and wait until they are cool before replacing the ATF.
1. Remove the oil pan. (See CONTROL VALVE BODY REMOVAL.)
2. Disconnect the TFT sensor connector.
3. Remove the TFT sensor.
4. Install a TFT sensor.
5. Connect the TFT sensor connector.
6. Install the oil pan. (See CONTROL VALVE BODY INSTALLATION.)
7. Carry out the mechanical system test. (See MECHANICAL SYSTEM TEST.)
Transaxle fluid temperature (tft) sensor inspection
On-Vehicle Inspection
1. Disconnect the negative battery cable.
2. Remove the air cleaner component. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
Caution
Water or foreign objects entering th ...
Oil pressure switch inspection
Caution
Water or foreign objects entering the connector can cause poor
connection or corrosion. Be sure not to drop water or foreign objects on the
connector when disconnecting it.
On-veh ...
Other materials:
Mazda 6 Service Manual: Interior Lights
NOTE
Do not leave the lights on for long periods while the engine is turned off.
Otherwise the battery power could be depleted.
Overhead Lights
NOTE
The rear map lights also turn on and off when the overhead light switch is
operated.
Front Map Lights
When the overhead light switch is i ...
Mazda 6 Service Manual: Air filter inspection
1. Remove the air filter.
2. Inspect the air filter.
If the air filter is damaged, excessively dirty, or foul smelling,
replace the air filter.
Note
The air filter cannot be reused by cleaning it with water or
compressed air.
Replace the air filter at the following interval, depe ...