Mazda 6 Service Manual: Remote handle lever removal/installation
4SD
1. To remove the remote wire, remove the trunk side trim.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
5HB
1. To remove the remote wire, remove the trunk side upper trim and trunk side trim.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Rear seat disassembly/assembly
4SD
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
5HB
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse o ...
Seat back striker removal/installation
1. Remove the tire house trim.
2. Remove the trunk side upper trim and trunk side lower trim.
3. Remove the bolts.
4. Remove the seat back striker.
5. Install in the reverse order of removal. ...
Other materials:
Mazda 6 Service Manual: Direct Mode
Direct mode can be used for temporarily switching gears by operating the steering
shift switch while the vehicle is being driven with the selector lever in the D
range.
While in direct mode, the D and M indication illuminate and the gear position
in use is illuminated. Direct mode is canceled ...
Mazda 6 Service Manual: General procedures
PRECAUTION (SUSPENSION)
Wheels and Tires Removal/Installation
When a wheel is installed, tighten it to 88-118 N·m {9.0-12.0 kgf·m,
65.0-87.0 ft·lbf}.
Suspension Links Removal/Installation
Tighten any part of the suspension that uses rubber bushings only after the
vehicle has been lowered ...