Mazda 6 Service Manual: Seat
Mazda 6 Service Manual / Body / Seat
- Front seat removal/installation
- Front seat disassembly/assembly
- Rear seat removal/installation
- Rear seat disassembly/assembly
- Remote handle lever removal/installation
- Seat back striker removal/installation
- Power seat switch inspection
- Front tilt motor inspection
- Rear tilt motor inspection
- Slide motor inspection
- Recliner motor inspection
- Seat warmer switch removal/installation
- Seat warmer switch inspection
- Seat warmer unit inspection
Child restraint seat anchor removal/installation
1. Remove the cover.
2. Remove the bolt and child restraint seat anchor.
3. Install in the reverse order of removal. ...
Front seat removal/installation
Warning
Handling the front seat (side air bag) improperly can accidentally
deploy the side air bag, which may seriously injure you. Read AIR BAG SYSTEM
SERVICE WARNINGS before handling the f ...
Other materials:
Mazda 6 Service Manual: Compression pressure
COMPRESSION INSPECTION
Warning
Hot engines and oil can cause severe burns. Be careful not to burn
yourself during removal/installation of each component.
1. Verify that the battery is fully charged.
Recharge it if necessary. (See BATTERY INSPECTION.)
2. Warm up the engine to the no ...
Mazda 6 Service Manual: Battery inspection
Battery
Inspect the battery in the following procedure.
Test load chart
Battery positive voltage with load
Back-up Current
1. Verify that the engine switch is at OFF and that the key has been removed.
2. Disconnect the negative battery cable.
3. Measure the back-up current between the n ...
© 2016-2026 Copyright www.mazda6info.net