Mazda 6 Service Manual: Rear door garnish removal
1. Disengage the door garnish clips using a fastener remover.
2. While cutting the double-sided adhesive tape using a screwdriver or a razor, separate the rear door garnish from the body.
Warning
- Using a razor with bare hands can cause injury. Always wear gloves when using a razor.
3. Remove the rear door garnish.
Rear flap removal/installation
1. Remove the screws.
2. Remove the rear flap.
3. Install in the reverse order of removal. ...
Rear door garnish installation
Note
Double-sided adhesive tape has already been attached to the new
rear door garnish.
Warning
Using a razor with bare hands can cause injury. Always wear gloves
when using a razor.
...
Other materials:
Mazda 6 Service Manual: Constant Monitoring
The following components of the air bag systems are monitored by a diagnostic
system:
Crash sensors, and diagnostic module (SAS unit),
Front air bag sensors
Air bag modules
Side crash sensors
Air bag/Front seat belt pretensioner system warning light
Front seat belt pretensioners
Re ...
Mazda 6 Service Manual: Procedures for determining the location of a malfunction
System Wiring Diadram
PCM
1. Check the display of DTC U0121 and/or U0155, using the SST (WDS or
equivalent). (See DTC TABLE.)
2. Referring to the following table, determine the malfunctioning part of the
CAN system.
ABS/TCS HU/CM or DSC HU/CM
1. Accec and monitor the PCM MSG and IC MSGo ...