Mazda 6 Service Manual: Rear spoiler removal/installation
1. Remove the trunk lid trim. (4SD)
2. Remove the liftgate lower trim. (5HB)
3. Remove the bolts.
4. Disconnect the high-mount brake light connector. (4SD)
5. Remove the rear spoiler.
6. Install in the reverse order of removal.
Rear finisher removal/installation
1. Remove the trunk lid trim (4SD).
2. Remove the liftgate lower trim (5HB).
3. Remove the nuts.
4. Pull the rear finisher toward you, then disengage clip A from the body.
5. Install in the reve ...
Roof carrier bracket removal/installation
1. Remove the headliner.
2. Remove the nuts.
3. Remove the roof carrier bracket.
4. Install in the reverse order of removal. ...
Other materials:
Mazda 6 Service Manual: Dtc table
Note
Perform the following if the security light stays on:
- If gasoline engine stalls, go to symptom troubleshooting NO.11
ENGINE STALLS/QUITS, ENGINE RUNS ROUGH, MISSES, BUCK/JERK,
HESITATION/STUMBLE, SURGES in. (See NO.11 ENGINE STALLS/QUITS, ENGINE RUNS
ROUGH, MISSES, BUCK/J ...
Mazda 6 Service Manual: Battery
WARNING
Wash hands after handling the battery and related accessories: Battery
posts, terminals and related accessories contain lead and lead compounds, chemicals
known to the State of California to cause cancer and reproductive harm.
Read the following precautions
carefully before using th ...