Mazda 6 Service Manual: Fuel-filler lid and opener

Liftgate adjustment

1. Measure the gap and height between the liftgate and the body. 2. If not as specified, loosen the liftgate hinge installation bolts or the liftgate striker installation screws, and reposition the ...

Fuel-filler lid and opener removal/installation

1. To remove the fuel-filler lid opener, remove the left side trunk side trim (4SD) or trunk side lower trim (5HB). 2. To remove the fuel-filler lid opener cable, perform the following and turn o ...

Other materials:

Mazda 6 Service Manual: Rear oil seal
REAR OIL SEAL REPLACEMENT 1. Remove the flywheel. (MTX) (See CLUTCH UNIT REMOVAL/INSTALLATION) 2. Remove the drive plate. (ATX) (See DRIVE PLATE REMOVAL/INSTALLATION) 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. Rear Oil Seal Installation Note ...

Mazda 6 Service Manual: Climate control unit inspection
Full-auto Air Conditioner 1. Connect the all center panel connectors. 2. Turn the ignition switch to ON position. 3. Measure the voltage at each climate control unit terminal and refer to the terminal voltage list. If not as specified, inspect the parts listed under Action and the relate ...