Mazda 6 Owners Manual: Seat Belt Maintenance
1. Clean the soiled area by lightly dabbing it with a soft cloth soaked in a mild detergent (approx. 5%) diluted with water.
2. Wipe off the remaining detergent using a cloth soaked in clean water and wrung out well.
3. Before retracting seat belts which have been pulled out for cleaning, dry them off thoroughly and make sure there is no remaining moisture on them.
WARNING
If a seat belt appears frayed or has abrasions, have it replaced by an Authorized Mazda Dealer:
If a seat belts is used under such a condition, it cannot function at its full capacity which could result in serious injury or death.
Use a mild detergent to remove soiling from a seat belt:
If organic solvents are used for cleaning the seat belts or they become stained or bleached, there is the possibility of them becoming weakened and as a result, they may not function at their full capacity which could cause serious injury or death.
NOTE
Clean seat belts diligently if they get dirty. Leaving them uncleaned will make it difficult to clean them later, and it may affect the smooth retracting of the seat belt.
Interior Care
WARNING
Do not spray water into the vehicle cabin: Spraying water into the
vehicle cabin is dangerous as electrical devices such as the audio and switches
could get wet resulting in a malfunction ...
Vinyl Upholstery Maintenance
Remove dust and dirt from the vinyl upholstery using a brush or vacuum. Remove
soiling from vinyl upholstery using a leather and vinyl upholstery cleaner.
Upholstery Maintenance
1. Clean the soile ...
Other materials:
Mazda 6 Owners Manual: Oil cooler
LF, L3
1. Remove the under cover.
2. Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT.)
3. Remove the oil filter cover, and drain the engine oil into a container.
(See OIL FILTER REPLACEMENT.)
4. Remove in the order indicated in the table.
5. Use a clean rag to wipe off the m ...
Mazda 6 Owners Manual: Liftgate disassembly/assembly
1. Disconnect the negative battery cable.
2. Remove the liftgate lower trim.
3. To remove the liftgate outer handle and liftgate key cylinder, remove the
rear finisher.
4. To remove the stud ball, separate the stud ball and the stay damper.
5. Disassemble in the order indicated in the table.
...