On-vehicle Inspection
1. Verify that the battery is fully charged.
2. Crank the engine and verify that the starter rotates smoothly without any noise.
- Remove the starter and inspect the magnetic switch and the starter.
- Inspect the related wiring harness and the ignition switch.
No Load Test
1. Verify that the battery is fully charged.
2. Connect the starter, battery, voltmeter and ammeter as shown.
3. Operate the starter and verify that it rotates smoothly.
4. Measure the voltage and current while the starter is operating.
Specification
Mazda 6 Service Manual: Front door unit removal/installation
1. Remove the front door glass.
2. Remove the inner handle.
3. Remove the front door speaker.
4. Disconnect the power window motor connector, front door lock actuator
connector, power outside mirror connector.
5. Remove the door harness from the front door unit.
6. Remove the bolts.
7. Rem ...
Mazda 6 Service Manual: Rear drain hose removal
1. Remove the headliner.
2. Remove the trunk side trim. (4SD)
3. Remove the trunk side upper trim and trunk side trim. (5HB)
4. Disconnect the rear drain hose from the sunroof frame.
5. Remove the rear drain hose from the clips.
6. Pull the rear drain hose into the room side.
7. Remove the rea ...