Mazda 6 Owners Manual: To Temporarily Cancel

Mazda 6 Owners Manual / When Driving / Cruise Control (Some models) / Cruise Control Switch / To Temporarily Cancel

To temporarily cancel the system, use one of these methods:

Slightly depress the brake pedal.
(Manual transaxle)
Depress the clutch pedal.
Press the OFF/CANCEL switch.

If the RESUME/

switch is
pressed when the vehicle speed is 25 km/h (16 mph) or higher, the system reverts to the previously set speed.

NOTE

If any of the following conditions occur, the cruise control system is temporarily canceled.
- The parking brake is applied.
- (Automatic transaxle)
  The selector lever is in the P or N position.
- (Manual transaxle)
  The shift lever is in the neutral position.
When the cruise control system is temporarily canceled by even one of the applicable cancel conditions, the speed cannot be re-set.
(Automatic transaxle)
The cruise control cannot be cancelled while driving in manual mode (selector lever shifted from D to M position). Therefore, engine braking will not be applied even if the transaxle is shifted down to a lower gear. If deceleration is required, lower the set speed or depress the brake pedal.

To Resume Cruising Speed at More Than 25 km/h (16 mph)

If some other method besides the OFF/ CANCEL switch was used to cancel cruising speed (such as applying the brake pedal) and the system is still activated, the most recent set speed will automatic ...

To Deactivate

When a cruising speed has been set (cruise set indication (green) turns on) Long-press the OFF/CANCEL switch or press the OFF/CANCEL switch 2 times. When a cruising speed has not been set (cruise ma ...

Other materials:

Mazda 6 Owners Manual: System Canceling
When the Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS) is turned off, press the Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS) OFF switch. The Lane-keep Assist System (LAS) & Lane Departure Warning System (LDWS) OFF indicator light tu ...

Mazda 6 Owners Manual: Rear door lock actuator inspection
Door Lock Actuator 1. Disconnect the front door lock actuator connector. 2. Apply battery positive voltage to the front door lock actuator terminals and inspect the operation of the front door lock actuator. If not as specified, replace the front door lock actuator. With double locking ...