Caution
1. Disconnect the negative battery cable.
2. Remove the under cover.
3. Disconnect the VSS connector.
4. Remove the VSS.
5. Apply ATF to a new O-ring and install it on a new VSS.
6. Install the VSS.
Tightening torque
8-11 N·m {82-112 kgf·cm, 71-97 in·lbf}
7. Connect the VSS connector.
8. Install the under cover.
9. Connect the negative battery cable.
Mazda 6 Service Manual: STEP 2: Contact Mazda North American Operations
If for any reason you feel the need for further assistance after contacting your
dealership management or it becomes necessary to have the components or wiring system
for the supplementary restraint system modified to accommodate a person with certain
medical conditions in accordance with a ce ...
Mazda 6 Service Manual: Sst
Some Ford SST or equivalent are used as SSTs necessary for
engine repair. Note that these SSTs are marked with Ford SST
numbers.
Note that a Ford SST number is written together with a
corresponding Mazda SST number as shown below.
Example (section ST)
Example (except section ST)
...