Mazda 6 Service Manual: Wheel hub, steering knuckle pre-inspection
Wheel Bearing Play Inspection
1. Position a dial indicator against the wheel hub.
2. Push and pull the wheel hub by hand in the axial direction and measure the wheel bearing play.
Maximum wheel bearing play 0.05 mm {0.002 in}
3. If the bearing play exceeds the specification, replace and tighten the locknut to the specified torque and retest.
- Replace the wheel bearing as necessary.
Front axle
...
Wheel hub bolt replacement
1. Remove the hub bolt using the SSTs.
Note
If the dust cover interferes with the wheel hub bolt and the wheel
hub bolt cannot be removed, tap the part shown in the figure with a chisel
l ...
Other materials:
Mazda 6 Service Manual: Engine tune-up
IGNITION TIMING INSPECTION
Note
Ignition timing is not adjustable.
Ignition timing verification requires WDS or equivalent.
1. Turn off the electrical loads.
2. Warm up the engine as follows.
(1) Start the engine.
(2) Maintain the engine speed at approx. 3,000 rpm until the
cooli ...
Mazda 6 Service Manual: Seek Switch
AM/FM radio
Press the seek switch ( ,
). The radio switches to the next/previous
stored station in the order that it was stored.
Press and hold the seek switch (
,
) to seek all usable stations at
a higher or lower frequency whether programmed or not.
Radio stations which have been previ ...