Mazda 6 Service Manual: Wheel hub bolt replacement
1. Remove the hub bolt using the SSTs
.
Note
- If the dust cover interferes with the wheel hub bolt and the wheel hub bolt cannot be removed, tap the part shown in the figure with a chisel lightly and bend the processing point back to the steering knuckle side.
2. Install the hub bolt into the wheel hub and install a washer and hub nut on the hub bolt.
3. Tighten the hub nut while holding the wheel hub using a brass bar.
Wheel hub, steering knuckle pre-inspection
Wheel Bearing Play Inspection
1. Position a dial indicator against the wheel hub.
2. Push and pull the wheel hub by hand in the axial direction and measure the
wheel bearing play.
Maximum wheel ...
Wheel hub, steering knuckle removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing ...
Other materials:
Mazda 6 Service Manual: Radiator cap
Warning
Never remove the radiator cap while the engine is running, or when
the engine and radiator are hot. Scalding coolant and steam may shoot out
and cause serious injury. It may also damage the engine and cooling system.
Turn off the engine and wait until it is cool. Even then, be ve ...
Mazda 6 Service Manual: Control valve body removal
On-Vehicle Removal
Warning
Using compressed air can cause dirt and other particles to fly
out, causing injury to the eyes. Wear protective eyes whenever using
compressed air.
Caution
Clean the transaxle exterior throughout with a steam cleaner or
cleaning solvents before removal ...