On-Vehicle Removal
Warning
Caution
1. Disconnect the negative battery cable.
2. Drain the ATF into a separate suitable container. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT.)
3. Remove the under cover.
4. Remove the front tires and splash shield.
5. Remove the crossmember. (See FRONT CROSSMEMBER REMOVAL/INSTALLATION.)
6. Remove the oil pan.
7. Disconnect the transaxle connectors and transaxle fluid temperature (TFT) sensor connector.
8. Remove the oil strainer.
9. Remove the control valve body installation bolts A as shown, then remove the control valve body component as shown.
10. Remove the accumulators and accumulator springs.
Mazda 6 Service Manual: Traction Control System (TCS)
The Traction Control System (TCS) enhances traction and safety by controlling
engine torque and braking. When the TCS detects driving wheel slippage, it lowers
engine torque and operates the brakes to prevent loss of traction.
This means that on a slick surface, the engine adjusts automatically ...
Mazda 6 Service Manual: Pcm configuration
1. Connect the WDS to DLC-2.
2. Set up the WDS (including the vehicle recognition.)
3. Select Module programming.
4. Select Programmable module installation.
5. Select PCM and perform procedures according to directions on the WDS
screen.
Note
If PCM CONFIGURATION is successful, the PCM ...