Caution
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. After installation, inspect the front wheel alignment. (See FRONT WHEEL ALIGNMENT.)
Locknut Removal Note
1. Knock the crimped portion of the locknut outward using a small chisel and a hammer.
2. Lock the hub by applying the brakes.
3. Remove the locknut.
Wheel Hub Component Removal Note
1. Remove the wheel hub component using the SSTs
.
2. If the bearing inner race remains on the front wheel hub component, grind a section of the bearing inner race until approx. 0.5 mm {0.02 in}
remains. Then remove it using a chisel.
Wheel Bearing Removal Note
Remove the wheel bearing using the SSTs
.
Dust Cover Removal Note
Note
1. Mark the dust cover and steering knuckle for proper installation.
2. Remove the dust cover using a chisel.
Hub Bolt Removal Note
Note
Remove the hub bolts using a press.
Hub Bolt Installation Note
Install the new hub bolts using a press.
Dust Cover Installation Note
1. Mark the new dust cover in the same way as the removed one.
2. Align the marks of the new dust cover and the knuckle.
3. Install the new dust cover using the SSTs
.
Wheel Bearing Installation Note
Install the new wheel bearing using the SSTs
.
Wheel Hub Component Installation Note
Install the wheel hub component using the SSTs
.
Locknut Installation Note
Install a new locknut and stake it as shown.
Mazda 6 Service Manual: Engine coolant
ENGINE COOLANT LEVEL INSPECTION
Verify that the coolant level in the coolant reservoir is between the F and L
marks.
If the engine coolant level is below L, remove the radiator cap and add
coolant. (See COOLING SYSTEM SERVICE WARNINGS.)
ENGINE COOLANT REPLACEMENT
Warning
Drain the ...
Mazda 6 Service Manual: TCS/DSC Indicator Light
This indicator light stays on for a few seconds when the ignition is switched
ON. If the TCS or DSC is operating, the indicator light flashes.
If the light stays on, the TCS, DSC or the brake assist system may have a malfunction
and they may not operate correctly. Take your vehicle to an Auth ...