Mazda 6 Service Manual: Woofer inspection
1. Inspect for continuity between the audio amplifier connector terminals and woofer connector terminals using an ohmmeter.
- If not as specified, replace the related wiring harnesses.
2. Verify that there is battery positive voltage at the woofer connector terminal A (4SD) or C (5HB) using a voltmeter.
- If not as specified, replace the related wiring haness.
3. Inspect continuity between the woofer connector terminal B and body ground using an ohmmeter.
- If not as specified, replace the related wiring harness.
- If as specified, replace the woofer.
Woofer removal/installation
4SD
1. Disconnect the negative battery cable.
2. Remove the rear package trim.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5HB
1. Disconnect th ...
Noise filter removal/installation
Brake Light Noise Filter
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Rear Window Defroster Noise Filter ...
Other materials:
Mazda 6 Service Manual: Control Switches
Temperature control dial
This dial controls temperature. Turn it clockwise for hot and counterclockwise
for cold.
NOTE
When the mode is set to or
with the fan control dial in a
position other than 0 and the temperature control dial in the maximum cold position,
the air intake selector sw ...
Mazda 6 Service Manual: Oil cooler removal/installation
1. Disconnect the negative battery cable.
2. Drain the ATF into a container. (See AUTOMATIC TRANSAXLE FLUID (ATF)
REPLACEMENT.)
3. Remove the radiator. (See RADIATOR REMOVAL/INSTALLATION.)
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Add ATF to ...