Mazda 6 Service Manual: Woofer removal/installation
4SD
1. Disconnect the negative battery cable.
2. Remove the rear package trim.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5HB
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Tweeter inspection
1. Inspect for resistance between the tweeter terminals using an ohmmeter.
If not as specified, replace the tweeter.
2. To verify that the tweeter outputs sound, apply voltage to the tweete ...
Woofer inspection
1. Inspect for continuity between the audio amplifier connector terminals and
woofer connector terminals using an ohmmeter.
If not as specified, replace the related wiring harnesses.
2. V ...
Other materials:
Mazda 6 Service Manual: Seat Belt Maintenance
1. Clean the soiled area by lightly dabbing it with a soft cloth soaked in a
mild detergent (approx. 5%) diluted with water.
2. Wipe off the remaining detergent using a cloth soaked in clean water and wrung
out well.
3. Before retracting seat belts which have been pulled out for cleaning, dry ...
Mazda 6 Service Manual: Diagnostic trouble code number inspection
1. Remove the glove compartment.
2. Short the A/C check connector to the GND terminal using a jumper wire.
3. Shine a 60 W incandescent light from a height of approximately
100 mm {3.9 in} onto the solar radiation sensor.
Note
When incandescent light does not shine on the solar radiatio ...