Mazda 6 Service Manual: Assist handle removal/installation
1. Insert a screwdriver into the assist handle notch and remove the assist handle cover.
2. Pull the assist handle forward you, then remove the assist handle.
3. Install in the reverse order of removal.
Shock absorbing pad removal/installation
1. Remove the headliner.
2. Remove the fastener, then remove the shock absorbing pad.
3. Install in the reverse order of removal. ...
Sunvisor removal/installation
1. Remove the screws, then the sunvisor.
2. Disengage the center adapter (sunvisor stopper) from the body using a
fastener remover.
3. Install in the reverse order of removal. ...
Other materials:
Mazda 6 Service Manual: Heated oxygen sensor (ho2s) inspection
HO2S Voltage Inspection
Note
Perform the following inspection only when directed.
1. Warm up the engine and run it at idle.
2. Disconnect the HO2S connector.
3. Connect the voltmeter test leads to the following HO2S terminals:
HO2S (front and rear)
- (+) leadterminal A
- (-) le ...
Mazda 6 Service Manual: Opening the Hood
1. With the vehicle parked, pull the release handle to unlock the hood.
2. Insert your hand into the hood opening, slide the latch lever to the right,
and lift up the hood.
NOTE
The lever is located a little to the left of center when facing the vehicle.
3. Grasp the support rod in the pad ...