Mazda 6 Service Manual: Headliner

Liftgate lower trim removal/installation

1. Remove the liftgate upper trim. 2. Remove the liftgate side trim. 3. Pull the handle toward you, then remove the handle. 4. Pull the liftgate lower trim toward you, then disengage clips A, B a ...

Headliner removal/installation

1. Disconnect the negative battery cable. 2. Turn the seaming welt and weatherstrip over. 3. Remove the sunroof seaming welt. (vehicles with sunroof only) 4. Remove the A-pillar trims. 5. Remove t ...

Other materials:

Mazda 6 Service Manual: Variable tumble control system (vtcs) shutter valve actuator inspection
1. Remove the air hose. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.) 2. Disconnect the vacuum hose from the VTCS shutter valve actuator. 3. Connect a vacuum pump to the VTCS shutter valve actuator. 4. Apply vacuum and verify that the rod moves. If the rod dose not move, replace the intake ...

Mazda 6 Service Manual: Rear shock absorber removal/installation
Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropri ...