Mazda 6 Service Manual: Before repair procedure

Mazda 6 Service Manual / Fuel and emission control systems / Fuel system / Before repair procedure

Warning

Fuel vapor is hazardous. It can easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel.
Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death and damage. Fuel can also irritate skin and eyes. To prevent this, always complete the following Fuel Line Safety Procedure.

Fuel Line Safety Procedure

Note
Fuel in the fuel system is under high pressure also when the engine is not running.

1. Remove the fuel-filler cap and release the pressure in the fuel tank.

2. Remove the fuel pump relay.

3. Start the engine.

4. After the engine stalls, crank the engine several times.

5. Turn the ignition switch to LOCK position.

6. Install the fuel pump relay.

After repair procedure

Warning Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death and damage. When installing the fuel hose, observe Fuel Leakage Inspection described b ...

Other materials:

Mazda 6 Service Manual: Headlight zeroset
Note When the configuration is not set for the auto leveling control unit, headlight zeroset cannot be executed. 1. Adjust the tire air pressure to the specification. 2. Position the unloaded vehicle on a flat, level surface. 3. Connect the SST (WDS or equivalent) to the DLC-2. 4. Turn t ...

Mazda 6 Service Manual: Drive shaft (atx) disassembly/assembly
1. Disassemble in the order indicated in the table. 2. Assemble in the reverse order of disassembly. Boot Band (Wheel Side) Disassembly Note Note The boot band does not need to be removed unless it is being replaced. Remove the boot clamp with end clamp pliers as shown and discard the cla ...