Mazda 6 Service Manual: Advisory messages
- You'll find several Warnings, Cautions, Notes, Specifications and Upper and Lower Limits in this manual.
Warning
- A Warning indicates a situation in which serious injury or death could result if the warning is ignored.
Caution
- A Caution indicates a situation in which damage to the vehicle or parts could result if the caution is ignored.
Note
- A Note provides added information that will help you to complete a particular procedure.
Specification
- The values indicate the allowable range when performing inspections or adjustments.
Upper and lower limits
- The values indicate the upper and lower limits that must not be exceeded when performing inspections or adjustments.
Symbols
There are eight symbols indicating oil, grease, fluids, sealant, and SST
or equivalent use. These symbols show application points or use of these
materials during service.
...
Troubleshooting procedure
Basic flow of troubleshooting
DTC troubleshooting flow (on-board diagnostic)
Diagnostic trouble codes (DTCs) are important hints for repairing
malfunctions that are difficult to simulate.
Perfo ...
Other materials:
Mazda 6 Service Manual: Variable tumble control solenoid valve inspection
1. Remove the variable tumble control solenoid valve. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
2. Inspect airflow between the ports under the following conditions.
If not as specified, replace the variable tumble control solenoid valve.
If as specified, carry out the Circuit Open/Short ...
Mazda 6 Service Manual: Selector lever disassembly/assembly
1. Disassemble in the order shown in the figure.
2. Assemble in the reverse order of disassembly.
Connector Disassembly Note
1. Insert a thin piece of metal from the terminal side of the connector, and
press down the terminal locking tab.
2. Pull the terminal out of the connector. ...