Mazda 6 manuals

Mazda 6 Owners Manual: Camera and Sensors

Forward Sensing Camera (FSC)

The Forward Sensing Camera (FSC) detects lane indications and recognizes headlights, taillights and city lights during nighttime driving. In addition, it also detects the vehicle ahead, pedestrians, or obstructions. The following systems also use the Forward Sensing Camera (FSC).

The Forward Sensing Camera (FSC) is installed at the top of the windshield near the rearview mirror.

Refer to Forward Sensing Camera (FSC).

Radar sensor (front)

The radar sensor (front) functions by detecting the radio waves reflected off a vehicle ahead sent from the radar sensor. The following systems also use the radar sensor (front).

The radar sensor (front) is mounted behind the radiator grille.

Refer to Radar Sensor (Front).

Radar sensors (rear)

The radar sensors (rear) function by detecting the radio waves reflected off a vehicle approaching from the rear or an obstruction sent from the radar sensors. The following systems also use the radar sensors (rear).

The radar sensors (rear) are installed inside the rear bumper, one each on the left and right sides.

Refer to Radar Sensors (Rear).

i-ACTIVSENSE (Some models)
i-ACTIVSENSE is a collective term covering a series of advanced safety and driver support systems which make use of a Forward Sensing Camera (FSC) and radar sensors. These systems consist of activ ...

Adaptive Front Lighting System (AFS) (Some models)
The adaptive front lighting system (AFS) automatically adjusts the headlight beams to the left or right in conjunction with the operation of the steering wheel after the headlights have been turne ...

Other materials:

Mazda 6 Owners Manual: Trunk end trim removal/installation
4SD 1. Remove the fasteners. 2. Pull the trunk end trim upward, then disengage clips A, pins B, and hooks. 3. Remove the trunk end trim. 4. Install in the reverse order of removal. 5HB 1. Pull the trunk end trim upward, then disengage clips A, pins B, and hooks. 2. Remove the trunk end tr ...

Mazda 6 Owners Manual: Pid/data monitor inspection
  1. Connect the WDS or equivalent to the DLC-2. 2. Measure the PID value. Note Perform part inspection for the output device after PCM inspection. The PID/DATA MONITOR function monitors the calculated value of the input/output signals in the PCM. Therefore, if a monitored value ...

© 2016-2018 Copyright www.mazda6info.net