Mazda 6 Service Manual: Joint shaft disassembly/assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
Joint Shaft Disassembly Note
Disassemble the joint shaft.
Bearing Disassembly Note
Remove the bearing using the SSTs
.
Dust Seal (Right) Assembly Note
1. Apply grease to the new dust seal lip.
2. Install the new right side dust seal using the SSTs
.
Bearing Assembly Note
Install the new bearing using the SSTs
.
Dust Seal (Left) Assembly Note
1. Apply grease to the new dust seal lip.
2. Install the new left side dust seal using a steel plate and the SSTs
.
Joint Shaft Assembly Note
Assemble the joint shaft using a press and the SST
.
Joint shaft removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing ...
Drive shaft pre-inspection
1. Inspect the dust boot on the drive shaft for cracks, damage, leaking
grease, and looseness in the boot band.
2. Inspect the drive shaft for bends, cracks, and wear in the joint or
splines.
...
Other materials:
Mazda 6 Service Manual: Headlight leveling switch removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Headlight Leveling Switch Removal Note
1. Insert your hand from the lower side of the dashboard and squeeze the tabs
of the headlight leveling switch.
2. Pu ...
Mazda 6 Service Manual: AUX/USB mode
Audio can be heard from the vehicle's speakers by connecting a commerciallyavailable
portable audio unit to the auxiliary jack.
A commercially-available, non-impedance (3.5 ) stereo mini plug cable is required.
Contact an Authorized Mazda Dealer for details.
In addition, audio can be played fr ...