Mazda 6 Service Manual: Cargo compartment light inspection
1. Remove the cargo compartment light. (See CARGO COMPARTMENT LIGHT REMOVAL/INSTALLATION)
2. Inspect for continuity between the cargo compartment light terminals using an ohmmeter.
- If not as specified, replace the cargo compartment light.
Cargo compartment light removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal. ...
Cargo compartment light switch inspection
1. Remove the liftgate lower trim. (See LIFTGATE LOWER TRIM
REMOVAL/INSTALLATION)
2. Disconnect the cargo compartment light switch connector.
3. Inspect for continuity between the cargo compartmen ...
Other materials:
Mazda 6 Service Manual: Intermittent rear wiper relay inspection
1. Connect the connector to the intermittent rear wiper relay.
2. Connect the negative battery cable.
3. Measure the voltage at the intermittent rear wiper relay using voltmeter.
When inspecting terminal D for continuity, disconnect the intermittent
rear wiper relay connector.
4. If the ...
Mazda 6 Service Manual: Generator inspection
Generator Warning Light
1. Verify that the battery is fully charged.
Charge if necessary.
2. Verify that the drive belt deflection/tension is correct. (See DRIVE BELT
INSPECTION.)
If not as specified, replace the drive belt.
3. Turn the ignition switch to ON and verify that the gene ...