Mazda 6 manuals

Mazda 6 Service Manual: Interior lighting system

Mazda 6 Service Manual / Body electrical system / Interior lighting system

Running light unit inspection
1. Connect the connector to the running light unit. 2. Connect the negative battery cable. 3. Measure the voltage at the running light unit using voltmeter. When inspecting terminal D, H or P ...

Front map light removal/installation
1. Disconnect the negative battery cable. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. Front Map Light Removal Note 1. Insert a tape-wrapped flath ...

Other materials:

Mazda 6 Service Manual: Airflow mode actuator inspection
1. Connect battery positive voltage to terminal D or F and ground to terminal F or D of the airflow mode actuator. 2. Verify that the airflow mode actuator operates as shown below. If not as specified, replace the airflow mode actuator. 3. Verify that the resistance between the ter ...

Mazda 6 Service Manual: Front lower arm (front) removal/installation
1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. Front Lower Arm (Front) Ball Joint Removal Note Separate the ball joint from the knuckle using the SSTs. Front Lower Arm (Front) Bushing (Inner Side) Removal Note Press the bushing (inner side) out ...

© 2016-2026 Copyright www.mazda6info.net