Mazda 6 Service Manual: Trunk compartment light bulb removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Cargo compartment light switch inspection
1. Remove the liftgate lower trim. (See LIFTGATE LOWER TRIM
REMOVAL/INSTALLATION)
2. Disconnect the cargo compartment light switch connector.
3. Inspect for continuity between the cargo compartmen ...
Trunk compartment light switch inspection
1. Remove the trunk lid trim. (See TRUNK LID TRIM REMOVAL/INSTALLATION)
2. Disconnect the trunk compartment light switch connector.
3. Inspect for continuity between the trunk compartment light swit ...
Other materials:
Mazda 6 Service Manual: Compression pressure
COMPRESSION INSPECTION
Warning
Hot engines and oil can cause severe burns. Be careful not to burn
yourself during removal/installation of each component.
1. Verify that the battery is fully charged.
Recharge it if necessary. (See BATTERY INSPECTION.)
2. Warm up the engine to the no ...
Mazda 6 Service Manual: Steering gear and linkage removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing the following procedures, remove the
ABS wheel-speed sensor (axle side) and fix it to an appropri ...