1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.


3. Install in the reverse order of removal.
Panel Light Control Switch Removal Note
1. Insert your hand from the lower side of the dashboard and squeeze the tabs of the panel light control switch.
2. Pull the panel light control switch forward to remove it.
Glove compartment light bulb removal/installation
Panel light control switch inspectionMazda 6 Service Manual: Supplier identification procedure
Note
When asking the supplier (service center) for repair or
replacement, verify which supplier the module belongs to and enter in the
Audio Repair Order Form.
Identification With Printed Numbers/Label
1. Remove the audio unit.
2. Verify the supplier name written on the label attached ...
Mazda 6 Service Manual: Crankshaft position (ckp) sensor inspection
Note
Perform the following inspection only when directed.
Resistance Inspection
1. Disconnect the CKP sensor connector.
2. Measure the resistance between CKP sensor terminals A and B using an
ohmmeter.
If not as specified, replace the CKP sensor.
If CKP sensor resistance is okay, bu ...