Mazda 6 Service Manual: Clutch fluid inspection
Note
- A common reservoir is used for the clutch and brake system fluid.
- The fluid in the reservoir must be maintained between the MIN/MAX level during replacement.
Clutch fluid
...
Clutch fluid replacement
Caution
Be careful not to spill clutch fluid on a painted surface. If this
should happen, wash it off immediately.
Note
Do not mix different brands of clutch fluid.
Do not reuse the cl ...
Other materials:
Mazda 6 Service Manual: Variable intake-air system (vis) shutter valve actuator inspection (l3)
1. Remove the air hose. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.)
2. Disconnect the vacuum hose from the VIS shutter valve actuator.
3. Connect a vacuum pump to the VIS shutter valve actuator.
4. Apply vacuum and verify that the rod moves.
If the rod dose not move, replace the intake ma ...
Mazda 6 Service Manual: No.9 tcs off light stays on more than 4 seconds with ignition switch on
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while
doing the inspection to discover whether poor contact points are the cause
of any intermittent malfunction. If
there is a problem, check to make sure connectors, terminals and ...