Mazda 6 Service Manual: Cooling system service warnings
COOLING SYSTEM SERVICE WARNINGS
Warning
- Never remove the radiator cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding coolant and steam may shoot out and cause serious injury. It may also damage the engine and cooling system.
- Turn off the engine and wait until it is cool. Even then, be very
careful when removing the cap.
Wrap a thick cloth around it and slowly turn it counterclockwise to the first stop. Step back while the pressure escapes.
- When you are sure all the pressure is gone, press down on the cap using the cloth, turn it, and remove it.
Location index
...
Engine coolant
ENGINE COOLANT LEVEL INSPECTION
Verify that the coolant level in the coolant reservoir is between the F and L
marks.
If the engine coolant level is below L, remove the radiator cap and add
c ...
Other materials:
Mazda 6 Service Manual: Front door trim removal/installation
1. Disconnect the negative battery cable.
2. Open the cap using a small screwdriver, then remove the screw.
3. Remove the inner handle cover.
4. Remove the inner garnish.
5. Remove the cover, then remove screw A.
6. Remove the lens cover, then remove screw B.
7. Disengage clips A from the ...
Mazda 6 Service Manual: Rear drain hose installation
Caution
If the rear drain hose is pinched or bent anywhere, the water in the hose may
not discharge and enter the inside of the vehicle. During and after installation
of the trims and the headliner, always make sure there is no interference with
the rear drain hose. Fix any problem if foun ...