Mazda 6 Service Manual: Dtc 21

Dtc 19

Dtc 22

Other materials:

Mazda 6 Service Manual: Pcm configuration
1. Connect the WDS to DLC-2. 2. Set up the WDS (including the vehicle recognition.) 3. Select Module programming. 4. Select Programmable module installation. 5. Select PCM and perform procedures according to directions on the WDS screen. Note If PCM CONFIGURATION is successful, the PCM ...

Mazda 6 Service Manual: Rear coil spring removal/installation
1. Remove the rear auto leveling sensor. (See REAR AUTO LEVELING SENSOR REMOVAL/INSTALLATION.) 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. 4. Adjust the headlight zeroset. (See HEADLIGHT ZEROSET.) 5. Inspect the rear wheel alignment. (See REAR WHE ...