Mazda 6 Service Manual: On-board diagnostic
Mazda 6 Service Manual / Heater and air conditioner systems / On-board diagnostic
- Diagnostic trouble code number inspection
- Dtc 02
- Dtc 06
- Dtc 07
- Dtc 10
- Dtc 11
- Dtc 12
- Dtc 13
- Dtc 14
- Dtc 15
- Dtc 18
- Dtc 19
- Dtc 21
- Dtc 22
- Dtc 58
- Dtc 59
- Dtc 02, 18, 21 (when two or more dtcs are indicated at the same time)
- Dtc 06, 10, 12, 14, 18, 21 (when two or more dtcs are indicated at the same time)
- Dtc 07, 11, 13, 15, 19, 22 (when two or more dtcs are indicated at the same time)
- Dtc 19, 22 (when two or more dtcs are indicated at the same time)
Defroster switch inspection
1. Remove the climate control unit.
2. Inspect for continuity between the defroster switch terminals using an
ohmmeter.
If not as specified, replace the climate control unit.
...
Diagnostic trouble code number inspection
1. Remove the glove compartment.
2. Short the A/C check connector to the GND terminal using a jumper wire.
3. Shine a 60 W incandescent light from a height of approximately
100 mm {3.9 in} ont ...
Other materials:
Mazda 6 Service Manual: Air bleeding
1. Inspect the fluid level. (See POWER STEERING FLUID INSPECTION.)
2. Jack up the front of the vehicle and support it on safety stands.
3. Turn the steering wheel fully to the left and right several times with the
engine not running.
4. Reinspect the fluid level.
If it has dropped, add flui ...
Mazda 6 Service Manual: Front lower arm (rear) inspection
1. Remove the lower arm (rear) from the vehicle.
2. Inspect for damage, cracks, and bending.
3. Inspect the ball joint rotation torque.
(1) Rotate the ball joint five times.
(2) Measure the rotation torque using a suitable allen socket and a
torque wrench.
If not within the specif ...
© 2016-2026 Copyright www.mazda6info.net