Mazda 6 manuals

Mazda 6 Service Manual: Dtc 02


Diagnostic Procedure


Diagnostic trouble code number inspection
1. Remove the glove compartment. 2. Short the A/C check connector to the GND terminal using a jumper wire. 3. Shine a 60 W incandescent light from a height of approximately 100 mm {3.9 in} ont ...

Dtc 06
Diagnostic Procedure ...

Other materials:

Mazda 6 Service Manual: Rear bumper removal/installation
1. Disconnect the negative battery cable. 2. Remove the rear combination light. 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. Rear Bumper Removal Note Pull the rear bumper ends (wheel arch) outward to disengage with the bumper slider. Cautio ...

Mazda 6 Service Manual: A/c compressor removal/installation
1. Disconnect the negative battery cable. 2. Discharge the refrigerant from the system. (See RECOVERY.) (See CHARGING.) 3. Remove the right side splash shield and mudguard (L.H.D. only). 4. Loosen the drive belt and remove it. Caution If moisture or foreign material enters the refrigeration ...

© 2016-2026 Copyright www.mazda6info.net