Mazda 6 Service Manual: Dtc b1318

Mazda 6 Service Manual / Braking system / On-board diagnostic (abs/tcs) / Dtc b1318

Caution

When attaching the tester lead to the ABS (ABS/TCS) HU/CM harness connector, the SST (49 G066 001) must be used. (See ABS (ABS/TCS) HU/CM INSPECTION.)

Diagnostic procedure

Abs (abs/tcs) on-board diagnosis

On-Board Diagnostic (OBD) Test Description The OBD test inspects the integrity and function of the ABS (ABS/TCS) and outputs the results when requested by the specific tests. On-board diagnos ...

Dtc b1342

Caution When attaching the tester lead to the ABS (ABS/TCS) HU/CM harness connector, the SST (49 G066 001) must be used. (See ABS (ABS/TCS) HU/CM INSPECTION.) Diagnostic procedure ...

Other materials:

Mazda 6 Service Manual: Gate operator/Canadian Programming
Canadian radio-frequency laws require transmitter signals to “time-out” (or quit) after several seconds of transmission — which may not be long enough for HomeLink to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to “time-out ...

Mazda 6 Service Manual: General procedures
PRECAUTION (CLUTCH) Clutch Pipe Removal/Installation Note A common reservoir is used for the clutch and brake system fluid. 1. If clutch pipes have been disconnected any time during the procedure, add clutch fluid (brake fluid), bleed the air, and inspect for leakage after the procedure ...