Mazda 6 manuals

Mazda 6 Service Manual: Front axle

General procedures
PRECAUTION (FRONT AND REAR AXLE) Wheel and Tire Removal/Installation 1. The removal and installation procedures for the wheels and tires are not mentioned in this section. When a wheel is removed, ...

Wheel hub, steering knuckle pre-inspection
Wheel Bearing Play Inspection 1. Position a dial indicator against the wheel hub. 2. Push and pull the wheel hub by hand in the axial direction and measure the wheel bearing play. Maximum wheel ...

Other materials:

Mazda 6 Service Manual: Sunvisors
When you need a sunvisor, lower it for use in front or swing it to the side. Side Extension Sunvisors (Some models) The visor extender extends the sunvisor's range of sun shading. To use, pull it out. CAUTION When moving the sunvisor, retract the visor extender to its original position. O ...

Mazda 6 Service Manual: Heated oxygen sensor (ho2s) inspection
HO2S Voltage Inspection Note Perform the following inspection only when directed. 1. Warm up the engine and run it at idle. 2. Disconnect the HO2S connector. 3. Connect the voltmeter test leads to the following HO2S terminals: HO2S (front and rear) - (+) leadterminal A - (-) le ...

© 2016-2026 Copyright www.mazda6info.net