Mazda 6 Service Manual: Fuel-filler lid and opener

Liftgate adjustment

1. Measure the gap and height between the liftgate and the body. 2. If not as specified, loosen the liftgate hinge installation bolts or the liftgate striker installation screws, and reposition the ...

Fuel-filler lid and opener removal/installation

1. To remove the fuel-filler lid opener, remove the left side trunk side trim (4SD) or trunk side lower trim (5HB). 2. To remove the fuel-filler lid opener cable, perform the following and turn o ...

Other materials:

Mazda 6 Service Manual: Tire house trim removal/installation
4SD 1. Remove the rear scuff plate. 2. Remove the rear seat side. 3. Remove the fastener. 4. Pull the tire house trim upward, then disengage clips A from the body, and remove the tire house trim. 5. Install in the reverse order of removal. 5HB 1. Remove the rear scuff plate. 2. Pull the ...

Mazda 6 Service Manual: Input/turbine speed sensor removal/installation
1. Disconnect the negative battery cable. 2. Remove the battery and battery tray. 3. Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.) 4. Disconnect the input/turbine speed sensor connector. 5. Remove the input/turbine speed sensor. 6. Apply ATF to a new O-ring ...