Mazda 6 Service Manual: No.4 air intake mode does not change

Mazda 6 Service Manual / Heater and air conditioner systems / Troubleshooting / No.4 air intake mode does not change

When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while performing the inspection to discover whether poor contact points are the cause of any intermittent malfunctions. If there is a problem, check to make sure connectors, terminals and wiring harnesses are connected correctly and undamaged.

Diagnostic procedure

No.3 amount of air blown from vents does not change

Manual Air Conditioner Diagnostic procedure ...

No.5 no temperature control with climate control unit

Diagnostic procedure ...

Other materials:

Mazda 6 Service Manual: Combine sensor initialization procedure
1. Set the SST (WDS or equivalent) to the DLC-2 2. Access the active command mode and select the YAWRATE, then follow the indication on the monitor. 3. Select the LATACCEL and follow the indication on the monitor. STEERING ANGLE SENSOR REMOVAL/INSTALLATION (See COMBINATION SWITCH DISASSEMBLY ...

Mazda 6 Service Manual: Rear oil seal
REAR OIL SEAL REPLACEMENT 1. Remove the flywheel. (MTX) (See CLUTCH UNIT REMOVAL/INSTALLATION) 2. Remove the drive plate. (ATX) (See DRIVE PLATE REMOVAL/INSTALLATION) 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. Rear Oil Seal Installation Note ...