Mazda 6 manuals

Mazda 6 Service Manual: Rear heat duct removal/installation

1. Turn over the front floor covering. (See FRONT FLOOR COVERING REMOVAL/INSTALLATION.)

2. Remove in the order indicated in the table.



3. Install in the reverse order of removal.

Heater core inspection
1. Remove the A/C unit. (See A/C UNIT REMOVAL/INSTALLATION.) 2. Remove the heater core from the A/C unit. 3. Inspect for cracks, damage, and coolant leakage. If any problems are found, replace t ...

A/c compressor removal/installation
1. Disconnect the negative battery cable. 2. Discharge the refrigerant from the system. (See RECOVERY.) (See CHARGING.) 3. Remove the right side splash shield and mudguard (L.H.D. only). 4. Loosen ...

Other materials:

Mazda 6 Service Manual: Floor covering
FRONT FLOOR COVERING REMOVAL/INSTALLATION 1. Disconnect the negative battery cable. 2. Remove the front seats. (See FRONT SEAT REMOVAL/INSTALLATION.) 3. Remove the rear seat. 4. Remove the front scuff plates. 5. Remove the rear scuff plates. 6. Remove the console. 7. Remove the front side tri ...

Mazda 6 Service Manual: Actuator cable installation
1. Slide the lock lever in the direction shown by the arrow to unlock the adjuster. 2. Turn the ratchet ring to release lock in the direction shown by the arrow. 3. Install the actuator cable to the cruise actuator. Caution Due to the possibility of actuator cable damage, make sure th ...

© 2016-2026 Copyright www.mazda6info.net