Mazda 6 Owners Manual: Seat Belt

Automatic Locking Mode

Always use the automatic locking mode to keep the child-restraint system from shifting to an unsafe position in the event of an accident. To enable seat belt automatic locking mode, pull it all th ...

Fastening the Seat Belt

Position the lap belt as low as possible, not on the abdominal area, then adjust the shoulder belt so that it fits snugly against your body. ...

Other materials:

Mazda 6 Owners Manual: Variable air duct (vad) shutter valve inspection (l3)
1. Remove the air cleaner case. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.) 2. Disconnect the vacuum hose from the VAD shutter valve actuator. 3. Connect a vacuum pump to the VAD shutter valve actuator. 4. Apply vacuum and verify that the rod moves. If the rod dose not move, replace the a ...

Mazda 6 Owners Manual: Electrical troubleshooting tools
Jumper wire A jumper wire is used to create a temporary circuit. Connect the jumper wire between the terminals of a circuit to bypass a switch. Caution Do not connect a jumper wire from the power source line to a body ground. This may cause burning or other damage to wiring harnesse ...