Mazda 6 Owners Manual: Fastening the Seat Belt
Position the lap belt as low as possible, not on the abdominal area, then adjust the shoulder belt so that it fits snugly against your body.
Seat Belt
...
Unfastening the Seat Belt
Depress the button on the seat belt buckle. If the belt does not fully retract,
pull it out and check for kinks or twists. Then make sure it remains untwisted as
it retracts.
NOTE
If a belt do ...
Other materials:
Mazda 6 Owners Manual: Inspection of dtcs for condition detection mode
Note
The cruise set indicator light will illuminate for 3 seconds,
when condition detection mode is on.
If the RESUME/ACCEL switch on the cruise control switch is
malfunctioning, the cruise set indicator light will not give a correct
indication when you inspect the system.
1. Drive ...
Mazda 6 Owners Manual: Washer fluid-level sensor inspection
1. Disconnect the negative battery cable.
2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION)
3. Insoect for continuity between the washer fluid-level sensor terminals
using an ohmmeter.
4. Verify that the windshield washer motor operates.
If not as specified, replace the ...