Mazda 6 Service Manual: Shift-lock inspection
1. Turn the ignition switch to ON position.
2. Verify that the selector lever is in P position.
3. Depress the brake pedal and verify that the selector lever can be shifted from P position.
- If a malfunction is found, inspect the interlock cable. (See INTERLOCK CABLE INSPECTION.)
Key interlock inspection
Verify that the ignition key cannot be pulled out except in P position.
If a malfunction is found, inspect the interlock cable. (See
INTERLOCK CABLE INSPECTION.)
...
Other materials:
Mazda 6 Service Manual: Rear upper arm removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing the following procedures, remove the
ABS wheel-speed sensor (axle side) and fix it to an appropri ...
Mazda 6 Service Manual: Gate operator/Canadian Programming
Canadian radio-frequency laws require transmitter signals to “time-out” (or quit)
after several seconds of transmission — which may not be long enough for HomeLink
to pick up the signal during programming. Similar to this Canadian law, some U.S.
gate operators are designed to “time-out ...