Engine

Electrical System

*1 Q-85 is designed for i-ELOOP system. Only Q-85 should be used to ensure correct operation of i-ELOOP system. Consult an Authorized Mazda Dealer for details.
*2 Not for i-ELOOP system.
*3 This spark plug provides the SKYACTIV-G engine with optimum performance. Contact an Authorized Mazda Dealer for details.
CAUTION
When cleaning the iridium plugs, do not use a wire brush. The fine particulate coating on the iridium alloy and platinum tips could be damaged.
Lubricant Quality

Capacities
(Approximate Quantities)

Check oil and fluid levels with dipsticks or reservoir gauges.
Dimensions

Weights
U.S.A. and Canada

Mexico

Air Conditioner
The type of refrigerant used is indicated on a label attached to the inside of the engine compartment. Check the label before recharging the refrigerant.

Light Bulbs
Exterior light

*1 UNECE stands for United Nations Economic Commission for Europe.
*2 LED is the abbreviation for Light Emitting Diode.
Interior light

*Some models.
*1 UNECE stands for United Nations Economic Commission for Europe.
*2 LED is the abbreviation for Light Emitting Diode.
Tires
NOTE
The tires have been optimally matched with the chassis of your vehicle.
When replacing tires, Mazda recommends that you replace tires of the same type originally fitted to your vehicle. For details, contact an Authorized Mazda Dealer.
Check the tire pressure label for tire size and inflation pressure.
After adjusting the tire pressure, initialization of the tire pressure monitoring system is necessary to make the system operates normally.
Standard tire
(U.S.A. and Canada)

(Mexico)

1 person's weight: About 75 kg
Temporary spare tire
(U.S.A. and Canada)

(Mexico)

Lug nut tightening torque
When installing a tire, tighten the lug nut to the following torque.
108—147 N·m (12—14 kgf·m, 80—108 ft·lbf)
Identification Numbers
Personalization FeaturesMazda 6 Owners Manual: Rear wiper arm and blade removal/installation
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. Adjust the rear wiper arm and blade. (See REAR WIPER ARM AND BLADE
ADJUSTMENT)
Rear Wiper Arm Installation Note
Clean the rear wiper arm connector shaft using a wire brush before installing
the ...
Mazda 6 Owners Manual: Outside Temperature Display (Without Multi-information Display)
When the ignition is switched ON, the outside temperature is displayed.
NOTE
Under the following conditions, the outside temperature display may differ
from the actual outside temperature depending on the surroundings and vehicle conditions:
Significantly cold or hot temperatures.
Sudden ...