Mazda 6 Service Manual: Theft-deterrent control module removal/installation
1. Disconnect the negative battery cable.
2. Remove the center panel module. (See CENTER PANEL MODULE REMOVAL/INSTALLATION.)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Bonnet switch inspection
Note
Bonnet switch has a built-in bonnet lock.
1. Open the bonnet.
2. Disconnect the negative battery cable.
3. Remove the radiator grille.
4. Disconnect the bonnet switch connector.
5. Che ...
Theft-deterrent control module inspection
1. Remove the theft-deterrent control module without disconnecting the
connectors.
2. Measure the voltage at the theft-deterrent control module terminals as
indicated below.
3. Disconnect the th ...
Other materials:
Mazda 6 Service Manual: Removing a Flat Tire
1. Loosen the lug nuts by turning them counterclockwise one turn each, but do
not remove any lug nuts until the tire has been raised off the ground.
2. Place the jack on the ground.
3. Turn the jack screw in the direction shown in the figure and adjust the jack
head so that it is close to th ...
Mazda 6 Service Manual: Volume/Display/Sound Controls
Volume adjustment
Turn the commander switch volume dial.
The volume switch on the steering switch can also be pressed.
Display setting
Select the icon on the home
screen to display the Settings screen.
Select the tab to select the
item you would like to change.
Display OFF/Clock
The c ...